EJOT Cronimaks: safe direct screwing into high-strength steel

Special production method for high strength of thread edges

Bad Laasphe, (PresseBox) - Within industrial lightweight construction, high-strength steels that allow for a more filigree design and higher peak loads (e.g. snow loads) are more and more often employed. Moreover, import goods have higher strength volatilities. Thus the conventional self-tapping screwing of profiled plates or sandwich elements reaches its limit.

Laboratory tests show the strength of thread edges often does not suffice for a function-proof fastening. The reason is that while screwing, the thread edges are considerably deformed through the high-strength steel. Thus, a sufficient gearing with the engineering structure is not achieved. The consequence may be immense property damage or personal injury.

With the Cronimaks screw, EJOT has developed a solution for this kind of application. The self-tapping screw is made from austenitic stainless steel. Thanks to an innovative production process the thread edges achieve a particularly high edge strength.

Cut analyses of screwed construction parts prove the advantages of EJOT Cronimaks. They show that the screw accurately forms the internal screw thread. The thread edges remain intact.

In connection with the corrosion-proof design in stainless steel, this allows a function-proof fastening even in high-strength steels with all advantages offered by self-tapping screws.

- cost reduction due to unnecessary tapping
- fastening even in places to be reached from the outside only for greater design scope in the engineering structure (no lock nut necessary)

The EJOT Cronimaks is technically approved for the direct screwing of profiled plates and sandwich elements made from steel grade S355 (St 52-3). The Cronimaks may also be used in stainless steel with tensile strengths of up to 700 N/mm2 (German approvals Z-14.1-4 and Z-14.4-407).

Big principals are convinced by the performance of EJOT Cronimaks. Around 300.000 screws were installed in the largest production building of Scandinavia, the aluminium production plant of Norsk Hydro in More on Sunndalsora. Further sites are the multifunction arenas in Gelsenkirchen (Schalke) and in Dusseldorf.

Press releases you might also be interested in

Weitere Informationen zum Thema "Industrial Engineering":

Elektronikindustrie setzt auf kollaborative Roboter

Im­mer mehr Un­ter­neh­men aus der Elek­tro­nik­in­du­s­trie set­zen auf kol­la­bo­ra­ti­ve Ro­bo­ter, das be­rich­tet Ro­bo­tik­her­s­tel­ler Re­t­hink Ro­botics. Die Ro­bo­ter über­neh­men re­pe­ti­ti­ve Auf­ga­ben, da­mit sich Mit­ar­bei­ter an­spruchs­vol­le­ren Ar­bei­ten zu­wen­den kön­nen.


Subscribe for news

The subscribtion service of the PresseBox informs you about press information of a certain topic by your choice at a choosen time. Please enter your email address to receive the email with the press releases.

An error occurred!

Thank you! You will receive a confirmation email within a few minutes.

I want to subscribe to the gratis press mail and have read and accepted the conditions.